PSA: a 30-year sweep in Cleveland told me to stop brushing straight up, and my creosote numbers dropped
For the last 6 months I was running my standard brush straight up and down through the flue and thinking I had it clean, but an old guy on a job in Cleveland looked at my shop vac and said "that's powder, not flake, you're polishing the glaze." I switched to short back and forth passes with a smaller brush first to break the crust, then finished with the big one, and pulled twice as much soot out of a 9x13 liner last Tuesday. Do you all break up glazed creosote before the main brush, or am I the only one who was doing it backwards?
Are you sure that powder wasn't just leftover ash getting pulled through after the crust already broke loose on its own? Glazed creosote is hard and shiny like glass, and a small brush doing short back and forth passes usually just slides over it unless you already hit it with a chemical softener first. Twice the soot in the vac could also just mean you stirred up the loose stuff you normally leave sitting on the smoke shelf. What did the flakes actually look like when you dumped the vac, because that tells you more than the number on the liner?